Report as inappropriate

The Bed Mosfet for my rostock decided to smoke itself, so as my PR still doesn't have a heated bed, it now has a not cack control board. For the first time I can do prints without the extruder skipping steps at the drop of a hat.

I still use mine, it is definitely the biggest of the build areas I have. Until recently was still even using the original board, with just basic mods like y/z axis brackets, bearings oh and replacing the warped ass guide rods on the x axis. Then last couple of weeks it has been given an...alternate board. Has a bit more punch in the drivers than original PR board, so no more click of sadness from my extruder. so it is again my designated big stuff printer