Report as Inappropriate

You are reporting a comment on ToM Extruder Relay Fix as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.


I used this for quite a while before I upgraded to a stepper and it worked exactly as advertised.

I am an electronics moron so I have a question for you.

What would be the easiest way -- or is it even possible -- to change this circuit so that instead of keeping the motor on for 600ms it k
ept it on for more like 5 seconds?

I'm basically looking for the simplest way to get a simple switch to power the DC motor for about 5 seconds, if you have any ideas, I'll be very thankful.