Report as Inappropriate

You are reporting a comment on Cube Gears as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

Yes, I am already printing four gears at once. I have a kapton film platform, it's super sticky. The first layer is fine, sticks perfectly. I also have solidity set to 0, just like it says in your instructions. Problem is, as layers start building up, the corners of the gear teeth that stick out into air are curling up. It still prints and functions, but the gear teeth will curl, and then the next layer placed on top of the curled layer below it, will just flop down, because there is nothing there to support it any more.