Report as Inappropriate

You are reporting a comment on Revised Fully Printable Eggbot as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

The rods I used were 5/16 SAE because I had them around. They are just a hair smaller than 8mm rods. I designed it for 8mm, but 5/16 should work fine. :)

The lengths I used for the frame rods is around 8"

The egg idler rod was a bit shorter, about 6"