Report as Inappropriate

You are reporting a comment on Owl statue as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

FWIW, the two side by side owls I uploaded were printed using acceleration at 120mm/s and 0.1mm layer height. Each took about two hours forty-four minutes to print. The owl on the left used default SF50 settings, including perimeter slowdown of 50% and 1.0 mm retraction (reversal). The one on the right also used default SF50 settings BUT then perimeter slowdown and retraction were disabled and altshell and firmware deprime were instead used. Both came out quite nice.