Report as Inappropriate

You are reporting a comment on Labyrinth Gift Box as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

Making one on my Simple. Was nervous about fitting vertically, so scaled inside 75% and outside 77% (based on some comments below). Works well - if a bit sloppy. Printing new lid at 75%.

10% infill, 3 layers/loops, .29mm layer height.
A little over an hour per piece to print (free KISSlicer doesn't allow multiple models to be sliced together).