Loading

Report as inappropriate

You should change your name to Prolific! I wish I had the focus to output as much as you do. This is a very nice enclosure. Can I make a couple a couple of wish list suggestions?

  1. The fan mount can still do its job of holding in the lid, even if it breaks away. Why not make it a separate part, so it can print flat? It would be stronger.

  2. Along the inside walls of the main body, put a pair of embedded tubes, 1.8mm and 3.5mm in diameter. Since this part is prone to delams when printed in ABS, inserting a piece of filament into each side will insure that the case stays together.