Report as Inappropriate

You are reporting a comment on Filament Width Sensor Prototype Version 3 as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

Hello, Flipper. Many thanks for your excellent work on this project. I've printed the housing and received your pre-built kit via Storenvy, which was a real time-saver. The device works swimmingly, with one caveat (isn't there always one?) that I would appreciate your insight on. I can measure a minimum diameter of my series of gage pins of 0.93mm before the reading drops to zero. Anything smaller than .037" or so seems to disappear to the sensor. Again, I'd appreciate any guidance you could give me on getting this reading down to lower diameters. Ideally, I'd keep on seeing down to around 0.25mm... Thanks, Flipper.