Loading

Report as inappropriate

Can you upload your configuration files for 2.0.9, I ordered mag balls so the only difference between ours is I have yet to ground out the a4988 pins and I am using the OMG v2s extruder. My filament sensor was fine, I can not figure out why it's setting the z to 400 after filament change instead of going to home it stops hard. I noticed the z had changed in the settings to 400mm tho it's set in software and at the start shows the correct 417mm z. I'm going to start with a new marlin 2.0.9 so I would like something to compare too.