Hi, im running the stock board right now and ive upgraded to a BMG clone, ive been loking around on how i can change de E-steps.
So through cura i send the comands.
-1rst thing ive done is send G1 E100 F100 so it extrudes 100mm
-Im getting a value of 93mm
I dont think the comand values i send in are working correctly because ive changed this value several times (M8011 S) and saving with M8500 and the measurement on extrusion is the same.
Did manage to change the extruding direction.
Any help? is there anything im not doing?