Loading

Report as inappropriate

Status update: Upgraded to RAMPS a while back. Recently added a bowden v6 with BMG extruder using shawdreamer's STLs (thanks!). Just now upgraded further to a Klipper setup.

Had some issues with shawdreamer's extruder assembly but it works! I had to use the Dremel on my print to make everything fit nicely and might use the analysis to design a more optimal fan duct. An airflow analysis of the fan duct shows there's substantial room for improvement. I might post a remix on some parts if time permits.

I'm still tuning in the klipper setup but it seems to work fine in general. The motors run more quietly and it's possible to bump the speed further.