Report as Inappropriate

You are reporting a comment on Mostly Printed CNC 525 MPCNC "F-25mm OD" as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

measured out the pieces and it is 3 mm, so i did print out the right part. was playing around with the tubing and depending on how i turned it around it did flow better on some part then others, so i may just pas thru the hols with a file to eat up the sides a bit fo give it a better flow. But i did found that the nut trap fo the 25mm tubing is to big, it actually reflects the OD of the tubing and dose not fit inside :) I could cut off the ends or scale it down, but by how much. Did any body else refer to this issue?