Loading

Report as inappropriate

Ok this turned out horrible for me, my printer decided that your supports are better of being spaghetti and did so. However it still printed well and looked good just a lot of clean up. I had to scale to 85% to fit on my printed. However when I put my laptop inside it, tight fit felt perfect, came back and laptop was on the floor, it seems that printing this in its native orientation doesn not provide good support as its week points are in a terrible location, it's worth turning it on its side and using your own support which is what I might do but abit discouraged to reprint due to the amount of wasted filament and 8 hours print time.