Loading

Report as inappropriate

No problem!
The turret is the only thing that failed on my first attempt at printing these. I just ran it through Netfabb and it cleaned up a lot of the problems the PreForm (Formlabs' software) was displaying on that piece. Printing currently. Once I have a completed set, I'll post up in the "made" section.

Also, to be clear (especially for others reading), there is a downloadable Netfabb software that can be used as well. Basic and pro. I tend to use the online version as I just need to run a quick repair on things. if the repair fails, then i go in with another software and clean up the object by hand.