You are reporting Micro swiss upgrade gets clogged easily as a violation of the Thingiverse Terms of Service.
I have read the Thingiverse Terms of service and I understand that falsely reporting violations can result in a ban from Thingiverse.
Thank you for taking the time to bring this matter to You are reporting Micro swiss upgrade gets clogged easily as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.
I installed the hot end again and I am printing a 3DBenchy.
But I hear the extruder pop, as if airt bubbels are escaping during extruding.
I also see it in the print. The printes lines are not nice and flat.
I already have 3 nozzles and the same happens with 2. So this must be something else...
Retraction is at 1mm, temp at 235° and bed at 60° (PLA)
I installed the hot end again and I am printing a 3DBenchy.
But I hear the extruder pop, as if airt bubbels are escaping during extruding.
I also see it in the print. The printes lines are not nice and flat.
I already have 3 nozzles and the same happens with 2. So this must be something else...
Retraction is at 1mm, temp at 235° and bed at 60° (PLA)