Report as Inappropriate

You are reporting a comment on Owl statue as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

I always sets following setting on new printers which works 9 of 10 times.

Infill speed: 60mm/s
Outer-shell speed: 20mm/s
Bottom-layer speed: 20mm/s

For PLA
Bed: 60 degree Celsius
Hotend: 205 degree Celsius (with filament cooling, otherwise I use 190)

For ABA
Bed: 100 degree Celsius
Hotend: 245 degree Celsius (without filament cooling)

I use a mixture of sugar and water as bedadhesive. (1/3 sugar and boiled for 5 min. Works REALLY good)