Report as Inappropriate

You are reporting a comment on Snap-on Filament Filter/Oiler as a violation of the Thingiverse Terms of Service. Thank you for taking the time to bring this matter to our attention. To help our team best respond to this issue please take a few moments to describe what brought this matter to your attention.

No problem. Baby steps. Can seem overwhelming at times. Base layer is critical. Get your bed leveled. Print a couple skirts and manually dial ( in your bed to make sure the skirt lines are even and printing well. Slow down to start. You can slowly up the speed until something breaks, later.

Base not sticking? My fav is cheap dollar store picture frame glass (or mirrors but make sure it's glass) on 0.5mm thermal pads (sticky but not adhesive) and a few light coats of Aquanet hairspray.

Layers crack/split easily? Up the temp. Possible lower the fan speed.
Hairy prints? Lower the temp.

Try to keep a few notes as you go. Change only one or two settings at a time.

"It's all about the base. No trouble."

Di3 Thumbwheel Bed Dial
by idig3d