Loading

Recent Topics

Help PLEASE

by JTShots

Im trying to make a robot using arduino and a 16 channel servo shield, but the robot to me not being autonomous is pointless. I have a pixhawk on hand but im not sure that would work. Is there anything else i could do. Any answers would be appreciated

View Comment

sharing SCL and SDA pin to both, 16 sevo and I2c boards

by willy1067

I need a bit of direction.

trying to connect an Adafruit PCA9685 16-Channel Servo Driver, and an Adafruit I2C FRAM Breakout right to the Adafruit Feather 32u4 Adalogger.
do both boards share the SCL and SDA pin?

View Comment

Community Chat

by kadse

Hey, if you want feel free to join our active Discord server about 3D Printing, Arduino, Raspberry Pi and other related maker topics!

Invite: https://discord.gg/WZyyYtA

chat community discord
View Comment

Motorized slider help! LOOKING FOR CODERS!

by Coolcrawler_

I want to make a motorized camera slider that would use standard Arduino components. I don't know that much about Arduino but I still understand what people talk about.

You can look at my picture that I made to try and get an understanding of what I want. It would be powered by a stepper motor with a timing belt. I would prefer to use a Arduino Nano but any microcontroller would work.

At the ends, there would be microswitches. I would have a potentiometer to control the speed in both directions. A 3 way rocker switch would have OFF, INFINITE, and ONE WAY. The normal position would be off. When switched to INFINITE, the slider would move to one side, hit the limit switch, then go to th other side, hit the limit switch, and repeat, until I turn it off (this would be for interviews or things like that.) Then, the other position (ONE WAY) would start where the position was last left off, then go to one side (determind by the potentiometer for speed and direction) and hit the limit switch, and then just stop. Also there might be a little "Reset button" which just moves the carriage to one side of the slider which would be defined as the "home position", similar to a 3D printer. The thing I need help with is the coding/wiring. I can't imagine this being that difficult to code for most people, and I am currently taking an Arduino course. These are the electronics I am thinking:

10K Potentiometer
Stepper motor
Stepper motor driver
Arduino-type board
2 limit switches
3 way rocker switch

So if anyone can help me, or need me to clarify stuf, please contact me!

arduino stepper
View Comment

Trinket 5V Error (Still!!!)

by mendeleev_the1st

Hello all,
So I'm trying to upload some code to my Trinket Pro 5v 16 MHz (USB) for the Neopixel strips attached to it, and I get the following error:
Using Port : usb
Using Programmer : stk500v2
avrdude: usbdev_open(): did not find any USB device "usb" (0x03eb:0x2104)

avrdude done. Thank you.

Programmer: AVRISP mkII
Board: Pro Trinket 5V 16 mHz USB

The tutorial on Adafruit says that when I press the reset button on the board, the red light should pulse for 10 seconds, which is when I should upload the code. My board doesn't do that. The light just comes on and goes back off. We've been using a USB cable that is used for uploading data, and this problem has followed us through the lands of Mac, Windows, and beyond. Please help with something besides "go to the Adafruit forums". If I wanted to do that, I would. Thanks!

View Comment