Predator controller board upgrade 2021
by MasterTinkerI am planning for upgrading the controller board in my Anycubic Predator. Is the SKR v1.3 stands to be a good option in 2021? Would you recommend something else, perhaps the SKR turbo v1.4 ?
I am planning for upgrading the controller board in my Anycubic Predator. Is the SKR v1.3 stands to be a good option in 2021? Would you recommend something else, perhaps the SKR turbo v1.4 ?
I have a SKR v1.3 installed into my Predator running Marlin bugfix-2.0.x . When I run delta auto-calibration the printer's height gets set to 471.8, way above the 455 it should be. The probe z-offset is set to -16.8, so it looks like marlin is subtracting the probe offset from the height. This can't be right since I can't get a proper z=0 to be level with the bed.
However, running a G29 to auto-level the bed makes the height 454.71, pretty close to printable and I can actually get some plastic on the bed if I babystep it. But, during a print the nozzle doesn't move correctly on the X & Y axis. It move diagonally up on the Z. Like, if it should be at X=0, Y=10 Z=0 it ends up at something like X=0, Y=7, Z=2.
There just doesn't seem to be any pattern and after three days I'm really running out of ideas. Any help would be greatly appreciated.
I included my marlin configuration file. Thank you!
Hello all!
I prepared github about swap SKR v1.3 .. if oyu find some issues or tips please let me know .. piece ..