Dremel 3D45 camera quality

by Beadsworth

Hi All,

On my Dremel 3D45, the camera quality is low. There are a lot of green artifacts on the image when it is recording. Are others having this issue?

I wasn't expecting an expensive camera. But it is supposedly 720p, which makes me wonder if the camera in my unit is defective. I'm just curious if this is the typical camera quality.

Here's a video that shows the quality:

3d45 camera
View Comment

Selling my 3D45 for €990,-

by 3DWatsch

Drop me a line if you are interested

View Comment

Dremel 3D40 platform issue

by Narnia1425

The back of the bed is too high in the back during printing and i cant move the bed up or down
anyone know what to do?

View Comment

New Dremel Digilab software for 3D20

by Codyacehardware

I haven't used Thingiverse groups much but I had to come search out other Dremel users to make sure they know.
Dremel released both a firmware update and new version of their Digilab slicer that hopefully makes the 3D20 a much more successful printer.
I've been using one for over two years now. It's been upgraded a few times. But the software was of course lacking. I used Print Studio pretty much exclusively once I found it (then windows 10 broke it, then fixed it again, thankfully.)
Digilab is based on Cura and is therefore a superior product from the get go. But much more importantly the new firmware supports printing plain gcode files. So any gcode slicer is an option now. So Craftware, real Cura, Kisslicer, Makerware, Matter Control, RepG, Slic3r and others are all a possibility.
I would consider the V1.5 firmware to still be a bit beta. I've had a couple of odd starts on files but so far mostly so good. The only thing lacking now is Dremel has to re-write the USB drivers(and get them submitted to and approved by Microsoft)... so you're stuck running prints from the SD card which I hadn't been in forever but ah well, the price of progress.
Hope this is useful info for everyone.
Thanks for reading,
Archie (Codyacehardware)

P.S. Just realized that this might open the door to Octoprint as well if they make the USB more standard. Exciting times.

View Comment

dremelprintcloud slicer

by makerbude

funktionier auch mit dem 3d20

layerheight 0,01 mm

View Comment


by Ruwenda

Seit heute kann keine neuen Objekte Drucken, es kommt immer: Fehler beim zerlegen! Es gibt kein Softwareupdate usw. Vielleicht hat einer von euch eine Lösung. Danke
Since today, no new objects can print, it always comes: error when disassembling! There is no software update, etc. Maybe one of you has a solution. Thank you

View Comment

Z off set

by reddutton

Being new in the 3d area I am not sure how or why I would determine the z-offset of the bed. That being said I do know I need to set it but not sure what value would be best as 0.0 was digging in to the build tape. I have moved it to +0.2 and have not had any digging in to the tape would this be a safe assumption to be made that this would be the correct off set ? And with the semi-auto leveling why would this be needed?

View Comment

Alternative filament

by Jeyell

Been liquefying Dremel filament like crazy, now looking for alternates. Proto Pasta (Carbon fibre) looks good with a matt finish, but difficult/expensive to source in UK/EU. Any other recommendations of good filament and suppliers in UK/EU?. I understand some of the exotics need a more durable (than brass) nozzle. Looking at a micro swiss nozzle top cope. Comments/experiences?

View Comment