HI, I'm new here. Been 3D printing with my Ender 3 Pro for about 2 years. I'm having an issue but I am not sure what to call the problem in order to research possible fixes for it. I was hoping maybe someone might be able to help me identify exactly what's going on with my prints? Please?
I recently had the extruder handle break and so I bought a new one. It was cheap and terrible and so I took the one off my other printer, which at first worked great, but two weeks into using it, my prints are terrible.
I've tried everything that I can think of so now I'm stuck. And it stinks and it's very frustrating.
The part in this photo is small. It's 22mm x 10mm.
Any idea what I am doing wrong or what's wrong with the printer / settings?
This is printed with PLA+ 220/60 degrees. It was printed standing up tall. Thank You. Any help would be very much appreciated!
If the problem continues, check that the lever arm has enough tension by tightening the screw.
You need to set your ESteps for the new extruder.
1st: https://www.youtube.com/watch?v=lH-RrjtiC8M or https://all3dp.com/2/extruder-calibration-6-easy-steps-2/
Thank You I will do it now and post back the results of the new print. Thanks again!