Due to shorting out my mainboard tightening up the nozzleI replaced it with a SKR Mini E3 and a also changed out the Extruder to a Micro Swiss direct drive and a Crealty Dual z axis. Now the issue is that one side of the Z axis goes up and the other goes down. I switched cable around but some the happens only in reverse. Could use some help[ on this. Thanks.
Due to shorting out my mainboard tightening up the nozzleI replaced it with a SKR Mini E3 and a also changed out the Extruder to a Micro Swiss direct drive and a Crealty Dual z axis. Now the issue is that one side of the Z axis goes up and the other goes down. I switched cable around but some the happens only in reverse. Could use some help[ on this. Thanks.
Check YouTube, if i remember right..one pin has to be switched.
I've been looking all over Youtube. No fixes yet but here's exactly the issue I'm having.
https://www.youtube.com/watch?v=lTArAaRlhiY
Read this...https://www.reddit.com/r/ender3v2/comments/rv1mlv/second_z_stepper_turning_in_wrong_direction/
Thank you. Worked great.