Hi there. My employer recently bought a Flashforge Foto 13.3 MSLA printer and I've been trying to figure out how to get consistent prints off it. I ran some test rubber ducks over the weekend, and when I took them off the build plate, I've noticed that they all have this mis-alignment in them. Some are more out of alignment than others, but it's always there.
Does anyone have any ideas what could be causing this? I used Chitubox Basic to set up and slice the model. I've had more success with it than I did with Flashprint.
Hi there. My employer recently bought a Flashforge Foto 13.3 MSLA printer and I've been trying to figure out how to get consistent prints off it. I ran some test rubber ducks over the weekend, and when I took them off the build plate, I've noticed that they all have this mis-alignment in them. Some are more out of alignment than others, but it's always there.
Does anyone have any ideas what could be causing this? I used Chitubox Basic to set up and slice the model. I've had more success with it than I did with Flashprint.