bl touch + kimera + leveling problem

by 89stefano89

hi, i've seen many people use a bl touch with the cube. i have one bl touch for an other printer, but wich firmware must i use for the cube+kimera+bltouch?

i have some problem with the leveling, i use a glas bed but i have see that the center is always higer! i think the bar flex a little is it possible?

thanks to all

View Comment

Klipper Config File

by Greenblurr93

Anyone have a good config file for the klipper firmware? I have it all flashed and would make my life a ton easier to have a known good starting point.


View Comment

Core XY

by nebula39

I have upgraded my cube to a core xy printer. When i changed my Marlin firmware I have a problem. Y axis is saying it is triggered all the time. I have unplugged the end stop for the y axis and get the same error.
does anyone have any ideas for me?

View Comment

New Owner... Lots of lurking to come (probably questions too :)

by amidemon

Just thought I'd say hello. I had a FLSUN Cube given to me recently. A friend had it for over a year, but never got the quality of prints he wanted. Somewhere along the line he did something that made him think he fried the motherboard. He ordered another one, but couldn't get the firmware to load. After a week or so of failed attempts to revive it, he sent the motherboard back and told me the printer was free to a good home. I'm fairly new to 3d printing. I have a Tevo Tarantula that I bought about 4 months ago. I have been happy with it. Especially after several upgrades, such as aluminum brackets, layer fan, dual Z, and a mosfet. I have looked over the Cube I now have, and think his print quality issues were likely due to assembly. I think some careful re-assembly and adjustment will take care of a lot. At this time I am waiting for a new motherboard to arrive. I tried several times to load Marlin on the original, but it wasn't happening. The firmware will be my weak spot. I have very little experience setting up Marlin. However, in order to learn we have to start at the beginning. Please feel free to share any tips with me that you feel are worth mentioning. Thanks

FLSUN_Cube new
View Comment

Driver problems

by OV-10A

Just finished the construction and am trying to get to the first print. I'm using a laptop (Toshiba Satelite L850 ) with Win 7.
Having problems with the driver install and following the instructions included don't seem to work 4 me. I can see the driver copied to Sys32-drivers but keep getting a install fail msg and as the printer dosn't recognize the driver I cannot connect the printer.


View Comment

General problems

by Borule1

I bought and assembled an flsun cube and I have a few problems with it the major one being that over time the printer has degraded in usefulness, initially I was able to control the printer and adjust it with the program provided in the kit (repetier), however it can no longer control the printer and has an issue of not sending commands to the printer. Does anyone have any advice on what to do?

View Comment

anyone have a cura profile for FLsun Cube3D with cyclops

by angelether

I been searching the web furiously but cant find any profiles at all for the Flsun Cube.
if anyone has any at all plz let me know

View Comment

Simplify 3D Profile?

by CannaGeneticsBank

Just ordered my cube should be here thursday. Anyone can share Simplify 3D Profile Settings?

View Comment

flsun cube print settings

by thatbreadtastedgood

Hi, i got an flsun cube a few months ago and it broke, i was finally able to set apart enough time to fix it, im a beginner in this field so i was wondering if anybody knows some good settings for the printer in cura or repetier slicer/ cura. Thanks!

View Comment