Hashtags to use
by Awesome3DPrinter1234Hey Guys It would be helpful for thingiverse users if everyone that made a design related to stopping corona posts their things with #helpstopcorona or #corona or #HackThePandemic
thanks
Hey Guys It would be helpful for thingiverse users if everyone that made a design related to stopping corona posts their things with #helpstopcorona or #corona or #HackThePandemic
thanks
I'm trying to print Some ninjaflex TPU on an effectively stock CR-10S for the back half of a facemask. Any suggestions on ways that I can get it to print? I have not gotten a print to go successfully past about the tenth layer, it just kinda stops pushing plastic.
I have the number one hot end thermo issues . If is heat up and test only E1 all is good no issues . When I start heating up E2 then E1 will give a runaway error. After resetting Printer, and starting up all to heat up , I get a thermo run away with in 3 minutes , I have switched the E1 and E2 thermo plugs and still no reading on the what would be the bad thermo resistor. Replaced the resistor with 2 different new ones and still happens, Am I missing something ? Could the motherboard be bad ? Is there an update I should try ? This was new out of the box , Took my time to put together as I already own a A8 for 2 years and done all the upgrades and never had a issue with that one. Any help is greatly needed . Thank you .
Trying to figure out why my Ender Pro 3 is having issues printing.
Remixed from: https://www.thingiverse.com/thing:2829915
Modified to mount on the wall with standard 3.5mm screws and added bottom element to prevent bending of the ring. Scaled to 103% for a tight and secure fit
Trying to figure out why my Ender Pro 3 is having issues printing.
I'm making Ear Saver Bands that I'm donating to Hospitals, clinics and such. Along with them, I am including a Thank you sign and some magnetic No COVID badges that they can wear, give to kids or people who pull through a rough recovery.
badges - https://www.thingiverse.com/thing:4276353
Thank you Heroes sign - https://www.thingiverse.com/thing:4294634
Here's a shot at silicone casting a respirator in a 3D Printed Mold: