Hi I all, I have the d9 MK2.
I run and set the z offset with the auto bed leveling.
If I go back to the leveling it stays the same value and the distance from head to bed looks the same.
But when I run a print the z axis goes to low
Seems that the offset is not been added to my z position.
As anyone else had this issue?
I am thinking of flashing marlin V2 firmware any thoughts?
Hi I all, I have the d9 MK2.
I run and set the z offset with the auto bed leveling.
If I go back to the leveling it stays the same value and the distance from head to bed looks the same.
But when I run a print the z axis goes to low
Seems that the offset is not been added to my z position.
As anyone else had this issue?
I am thinking of flashing marlin V2 firmware any thoughts?