Loading

Turn K8200 into something like big prusa

by Justy_guy

I'll try to turn my old, anything but not reliable K8200 into something like prusa or CR10 with 300x300mm heatbed (I didn't figure out Z height yet, but seems like it can be way over 200mm). Already I have just frame and motors left, everything else is rebuilded :D... (Ramps 1.4 full graphic smart controler, 1,75mm direct drive extruder, J-head v6, GT2 belts, optical X and Y endstops, of course custom marlin fw and a lot more...)
Ithink I can use MK2S/MK2.5 X axis and extruder assembly, with one Z motor and belt connected leadscrews.
Is anyone interested in this project?

View Comment

K8206, E3D Titan and BLtouch

by Abeforth

Hy all..i need your experience..=)
So i have a K8200 and do alot of moddings on it..
What ive done.
-E3D V6 Hotend
-Tensioner dor x and y axis
-Upgrade the Headbett to 24V with a SSD Relais
Mount the Original Z axis Upgrade
Mount the original Borsolit glass

So atm im at work to upgrade it again...the controller K8201 and K8206 is allready orderet..
I orderet a E3D Titan and a BLtouch sensor to..

The new bed from K8206 isnt headet so i rebuild it by my own.

Now i have sone questions.
-is here someone how had installed the BLtouchsensor on his K8200 Printer and can tell me how to install the wires and what i must chance into the firmware?
Wen install The BLtoch can i remove the original Z endstop?

-Is here someone how had the K8206 too and can tell me what i must chance in the firmware for the bigger bed size?

-someone cab give me little tips to install the Titan?

I like to write how good the own rebuild of the new bed works..
And im sorry for my english..
Thx to all

View Comment

Pro switch box for K8200

by Justy_guy

I have this idea for looooong time... It is a printed case for a small switch. It has 2 main moving parts: protected start button and emergency stop button...
I need some ideas for this project like where to mount it on the printer and how to mount it on the printer.

View Comment

MKS Base conversion for K8200

by Middleman

Hi guys just letting you know I've posted full installation instructions and a mount STL for the MKS Base if you are interested in upgrading your machine > http://www.thingiverse.com/thing:1836898

Velleman K8200 MKS Base Conversion
View Comment

Mods for the K8200

by Yngel

Have any of you tried to modify your K8200? Change the bed? Change the hot end?

View Comment

upgrade heated bed to 24 V

by BVD

I want to upgrade my original heated bed to 24V so I can print ABS .
I was wondering is someone already have done it.
did they use the original heated bed or is it better to buy the MK3 heated bed ?

View Comment

Bulldog Lite super strong and simple mount for K8200/3Drag

by ivanccc

Just to report about my new design, check it out:

http://www.thingiverse.com/thing:881774

Bulldog Lite super strong and simple mount for K8200/3Drag
by ivanccc
View Comment

Hi!

by Puck3D

Hello guys.
3D and happiness to all...
CD

View Comment