Loading

Recent Topics

X-Carriage for Bondtech BMG

by Printbus

I'm putting together a new i3v x-carriage for the Bondtech BMG extruder and an e3dv6 hot end. Is there community interest in seeing this posted to Thingiverse? I'd need to clean up the openSCAD file to publish it. Options being incorporated into the openSCAD file include whether the eccentric spacer is on the top instead of the bottom, provision for a BLTouch bed sensor, provision for cable routing zip ties, and provision for mounting a 5015 blower BEHIND the rails for a part cooler.

View Comment

E3d Chimera

by batmanbat4

Has anybody tried to fit an e3d chimera on a Maker Farm i3v 12. I got it to fit on the printer and set up the extruders, but the firmware is what i need help with.

View Comment

Bowden adaptation

by vhoward1122

Has anybody thought about using an E3Dv6 in a bowden configuration where the extruder motor was mounted on the frame and not on the extruder carriage?

View Comment

Print fan

by batmanbat4

I have a fan cooling the heat sink of my e3d v6 connected to D9 and wanted to add 2 new 40mm fans, but when i connect all three fans to D9 they do not work. will i need to purchase a ramps fan extender or is something wrong with my board?

View Comment

Model request

by batmanbat4

Hi,
I am planning on using an e3d chimera, but need to make a new mount for it. As I am not very adept at 3d modeling, I am asking if someone could design a mount that could fit the e3d chimera well.
Thank you

View Comment