I've been asked more and more recently if I can print something for someone. One case I was asked to create something and print and recently I was asked to print something that the person had designed. They ask how much do I owe you and I never know what is too little or too much. My average price I give is $20. I know it depends on time, how big, etc. but just want to see if anyone has a process for their charge rate.
I need some help with changing some gcode. I want to change it to make it heat the nozzle after auto leveling cause I have a buildtak like surface on my printer and the nozzle loves to burn through it when its leveling so if you have any clue on how to do it or a line of code I could copy then that would be amazing
I figured that I should post this on here to see who would be interested before trying other sites.
As the title says, I want to try and my Robo R1+ to try and get a bit of cash. There is nothing wrong with the printer, in fact it still prints quite well even though it was not used over the summer.
The printer has everything that came with it besides the original feet (which can be easily fixed with a tpu print). I also upgraded it such that is has a LCD screen attached. On top of that, the other day the nozzle on the printer was replaced to a brand new brass nozzle. If purchased a brand new extruder as well as a steel nozzle would be included.
When I get the chance I will upload pictures of the printer if people are interested, as well as negotiate on the price. Hope to hear from someone and hope everyone has a good day.
Side Note: I am willing to ship the printer but ideally I would like to sell it to someone around the Pittsburgh area such that shipping could be avoided and it could be picked up or dropped off.
Hi! I have an R1+ and my picture shows the problems I'm having. It's almost as if random layers are missing. I'm printing with Hatchbox 1.75 (does it with all the colors I currently have: grey, blue, white, red) at 200C, 0.3 layer height, speed of 60 across the board (perimeter, infill, etc.). I tried clearing out any jams in the extruder and it goes right back to doing this. Is this a temperature problem? Do I need to go higher or lower temps?