Loading

Recent Topics

Using this with repetier

by Belaris

Has anyone used this with repetier and using slicer? The slicer config screen won't open, i am using a mac, is this the issue?

View Comment

tronxy x3 profile

by Atown203

So I'm new to 3d printing, i just got a tronxy x3. Does anybody have any suggestion on a cura profile for this machine.

View Comment

What does all this mean?

by Selkirke

So my daughter (15) and I (much much older) decided to get a Tronxy X3A for Christmas. When we bought this we knew there would be limited directions. This is a big giant experiment for both of us, and we love the challenge. However, We’re getting frustrated because we can’t figure out what all is happening for each setup action.
So when we prepare the extruded head, the directions say “auto home, then z-offset, then store memory, then load memory, then auto home, then bed level”. Figured out the z-offset, but why store memory, then load memory? What’s the difference? How do we change auto home? We crashed the extruded a coupe times already so hate to press too much further. Thanks

View Comment

Z Offset crash on plate after Glass plate installation

by Cyruswest

I bought a 4mm ULTRABASE glass plate. After installing it, however, the sensor stops the Z axis at 0.48mm. The minimum set Zoffset is 0.5 mm, so when I mold the first 0.30mm layer it is not extruded and sometimes the extruder hits the plate. I thought about changing the sensor to take another more sensitive one. Do you have any other suggestions to give me? Can I change the firmware settings if necessary? how can I do?

View Comment

Starts fine but then begins to drags on lower levels

by TheLastGuyLeft

It starts rlly well but with each layer the gap gets smaller and then it begins to drags on lower levels eventually causing complete dis alignment, fish printer and print plz help

View Comment