Loading

Dual extruder for X5S

Please Login to Comment

Comment has been deleted

i used the SKR1.3 for my x5s and dual extrusion and it worked great! i had the Triangle labs chimera on it as well using a mount i made and also using your linear rail conversion it worked really well

Comment has been deleted

the skr1.3 is great! i had the chimera and the cyclops is different than what you have linked , the cyclops needs both filaments loaded to work, the one you linked can work with jsut one and in my opinion is better, the chimera is nice but if i would do it again i would go with the one you have linked 2-1

https://www.ebay.com/itm/Upgraded-2-In-1-Out-Hotend-12V-24V-Dual-color-Bowden-Extruder-Kit-For-MK8-Titan/273992032676

Comment has been deleted

yeah that should work just fine , the skr is a 32bit board so flashing it is somewhat different but not too bad

Comment has been deleted

I used the SKR 1.3 with 2209 drivers because you could do Sensorless homing (no need for endstop switches anymore)

and to do the dual Z i used this
https://www.amazon.com/Parallel-Stepping-Diverter-Expanding-Diffuser/dp/B07KNMSDDZ

it worked great! and sensorless homing is really easy to setup if you want that, if not then get the 2208s it makes the printer so much quieter and the prints come out better imo, and since u are using 24v thats even better they drivers will run cooler

Comment has been deleted