Recent Topics

Universal Pellet Extruder V3 ZQ version

by coloursofdiscovery

Attached are a few photos of my current direction and experimentation with Mahor's extruder v3. I'm trying to overcome the following challenges with this new design:
Stability - the original design is a bit wobbly and flexible when mounted to the CR10, you can see in some of Maho's videos he has used aluminium to make the front and back plates, but as I don't have the tools to do this I wanted a 3D printed solution.
Dust and mess - if your active cooling is blowing air into the hopper and your printing with shredded wast plastic then you end up with bits of plastic getting blown everywhere. I wanted a different location for cooling (this is not a problem with pellets).
Prevent blockage - shredded wast plastic is very high friction and the pieces of it are very light so it dose not flow very well.
Make it easy to mount to my CR10 - now it mounts directly.

The design I have created also has some disadvantages too, its heavier, its much harder to print, it requires quite a lot of post processing and is much harder to assemble, so if your just printing with pellets and its stable enough for your use case then the original design would be easier to work with.

I printed the housing in Carbon-fibre PETG and the hopper in clear PETG. It was my first time using Carbon-fiber PETG but it printed very well and without problem, however it did take 26 hours on my FFCP! I will print more with this as it make super stiff, strong and light parts, better than anything I used before.

The stl's can be downloaded from here: https://www.thingiverse.com/thing:3032188

Universal Pellet Extruder V3 ZQ version
View Comment

Just purchased a V4

by nicholasav

Does anyone know how long I should expect to wait? There is no contact information on the website whatsoever (unless I'm just completely blind to it). I'm very excited to use the extruder, and this group puts me more at ease.

View Comment

Getting Started

by spidermurph

Well I am up and running. I got the 24v version for my Anycubic Chiron. I'm off to a good start with PLA. See the photo. Nice results and fun being able to adjust the colour on the fly.

Today I am starting to experiment with the PET bottle strips (The main reason I purchased the extruder). I think I will start with a big nozzle 1.5 - 2.0mm to prevent motor jamming. I will post my progress.

Thank you for making this group as there is nothing out there for users. This will be a good portal for us all to share our knowledge.

Anycubic Anycubic_Chiron Mahor XYZ
View Comment

PETG Help.

by spidermurph

Hi Guys

Has anyone had any luck with PET?

I have spent the whole day experimenting with Bottle Strips, PET Flakes and PET Virgin Pellets.

I have tried larger nozzles all the way up to 2.0mm.

All that happens it the motor jams up and nothing prints. I have had to strip down the unit twice to unblock it.
If anyone has had any luck with this and could offer any advice, I would be very grateful.

View Comment


by TuneRaw


I'm searching for a source to buy the hotend. It needs to fit the 8mm extruder screw I recently bought on aliexpress.
I like the design of the one in Mahor Stor (https://mahor.xyz/es/producto/210/). Extruder in this size will benefit a lot from the grooved barrel. But 70+€ is way to expensive. Does anybody know a good source where I can find another (less expansive) one?

Thanks for the help, have a good one.

8mm_screw brass_hotend grooved pellet_extruder
View Comment