I'm wondering if I should remove the print bed map that came on the printer before laying down the glass.
Does anyone have any experience to share?
I removed mine, because it adds another layer of insulation as is not necessary.
I removed my - heated it up and unsticked it, then used alcohol solution to remove excess glue leftovers.
And after that - put a thermal transfer silicon sheet (like those used inside electronics between chips and heatsinks) on the bed and glass over it.
Not really necessary. I left mine in place under my glass bed.
Looking for a "Like" button here ...
Anyhow thanks. That seems to be working, but I need to turn the build plate temperature up a few degrees.
Yes, that's true. There's a temp drop through the glass.