Loading

Recent Topics

Da Vinci 1.0 Pro - Flash and UnFlash Firmware

by Benrubles

So just really looking for a straightforward answer (if even possible) that I have been unable to find at all anywhere online.
I am looking to flash a 3rd party firmware onto my Da Vinci 1.0 Pro, but want to know if it is possible to re-flash the stock firmware in case I change my mind down the road... Thank you in advance for your time and help!

View Comment

Incorrect Temps on Boot

by am1165

I have a Da VInci 1.0 running Repetier .92 that I have been printing with for years now. All of a sudden upon boot my temps are WAY off from what they should be and have been historically. I thought at first that it was just a thermistor problem, so I replaced it, but am stuck with the same problem. I have an e3dv6 hotend with a brand new thermistor. Anybody have any ideas or similar experiences? Upon boot both the hotend and the heated bed read at 166 degrees C even when I completely disconnect the thermistor from the hotend.

View Comment

Need Help to Have a Missing cable

by 3dservz

Dear All,
Recently I have revived Davinici 1.0 3D Printer from my friend. I could not print because the cable from Build bed to main board has missing( not the Heating sensor).
When I try to print without connecting I get warning massage "For issue 0013"
I have contacted costumer service. they said cable cannot send alone unless you order new print bed. but that specific cable not come with printbed.
Kindly someone can help me solve the issue to run the printer.

Regards,
Anil

View Comment

3.3V and 5.0V LEDs are off on my printer

by JusTheo

Printer won't boot, Davinci 1.0A checked back panel to discover only 1 LED is on out of the 3 and it's the 12V LED that's on

What should I do?

At first it was just the one R57 resistor but now the 5V led turned off so I don't know what to do now

Any help would be appreciated, thanks!

View Comment