Monoprice Maker Select 3D Printer v2
Upgraded to RAMPS 1.4 using Repetier Firmware cause the Melzi board melted.
RepRapDiscount LCD case https://www.thingiverse.com/thing:1116163/#made
Fan duct was moved and replaced with https://www.thingiverse.com/thing:1246425 and https://www.thingiverse.com/thing:2253654
Bed Heater Cable Holder for Duplicator i3 & Maker Select https://www.thingiverse.com/thing:1641044
SwissMicro HotEnd replacement and will install a .3mm nozzle I already have at some point
Champion Y Plate and Heated Bed replacements, and repalced the Bearings with longer ones
It's a lot smoother and working better than when I bought it.
No I would not buy another one.
It's a good starter printer for someone who doesn't mind fixing and upgrading.
Does a decent enough job. Not disappointed other than the Melzi board melting.
I Am A…Maker
Tools I Use…
Printers: Monoprice 13860 Maker Select 3d Printer V2
Design Programs: Blender, Windows 10 3D builder
3D Design Skill Level