I plan on getting an E3D v6 Bowden hotend in the future. After reading on the forums on how the stock hotend has a tendancy to fail especially when using high ABS temps, and I didn't want to get stuck without a way to print them if my stock hot end fails.
Used IC3D Natural 1.75mm ABS
235 C Hotend 108 C Bed w/ Glue Stick
.25 Layer Height
5 Solid Top and Bottom layers
Had some bed separation on the top from incomplete glue stick. So I reprinted just the top in the center of the build plate same settings except for layer height .15mm and 3 Perimeters.