i made this with 70% infill at a temp of 210 with PLA but i have a problem its mirrored even tho in slicer it was not mirrored any one know why that is ?
your x or y axis motor wiring is reversed causing it to think it is printing the right way but yet the motor does the exact opposite. Remember that you cant just flip the connection to fix the problem, you also must go into the firmware and change the endstop settings or else the motor will drive the carriage into the opposite end of the printer. Or as TBRlshtar pointed out you can also tell the firmware to inverse the logic on the X (or Y) direction.
A quick way to see if my theory is correct is to go into the software of your choice that has manual controls (i.e. pronter face) and tell the printer to move left, right, forward, and back and see if the response is that of which you expected.
If you're using Marlin or something similar, you should have a setting that looks like:
define INVERT_X_DIR false
Set this to true, it'll make your models print correctly.
the temp is working fine im just not sure why it was mirrored with out me seting that
your temp is way too high for pla... try 190