I built this one using the standard little servo's.
i got to do something with a lot of wires.
This is my first try.
it should get better as I go.
Witch servo Do you use? Did it work? I would linke to build one baut 20€ each servo is to mutch
To answer your question on the type of servo's
I just used the small standard they only cost $20.00 for 10 of them,
the sevo's you mentioned cost around $20.00 each to $200.00 each
I just can't affored the types of servos your asking about.
Sweet what printer did you use?
Also what controller are you using?
I bought a 3d printer on e-bay for $750.00 and a 2nd one just like it for $500.00. There not from makerbot.
I am going to try to use a aurdino to operate it. I just have to learn c all over again so I'm going to work with the C++ 2013 I just downloaded if I can get it going. thanks Ron.