Printed on a Printrbot Simple Metal. I also added a switch to kill the speaker, and a headphone jack.
Used Ninjaflex Semiflex for the buttons.
you have a link for the switch? Thanks
Sorry, but it was a random switch I acquired from tearing down old electronics. Any switch with a small form factor should work just fine.
That is really nice. How di you add the kill-sound-switch and the headphone-jack? :)
To turn off the speaker, I just added a switch to the positive wire between the Amp and the PowerBoost.
For the headphone jack, I just wired up a very very short 3.5mm headphone extension cable, and plugged it directly into the pi. The volume is then controlled through the software.
Just drill a hole for the switch and jack, then glue them in place (I would have edited the files and modeled them in, but it was an afterthought.)