Loading
Glasswalker
cas000176

Revised Fully Printable Eggbot

Made by cas000176, uploaded

Revised Fully Printable Eggbot Made by cas000176 Dec 30, 2015

Source

Revised Fully Printable Eggbot by Glasswalker Mar 30, 2012

Description

Used eggduino on a Uno 3
Commented out the couple of eeprom lines that would not compile in the sketch.

In Inkscape eggbot.py file commented out the lines right below

            # Try any devices which seem to have EBB boards attached

like this

            # for strComPort in eggbot_scan.findEiBotBoards():
    #   serialPort = self.testSerialPort( strComPort )
    #   if serialPort:
    #       self.svgSerialPort = strComPort
    #       return serialPort

Used A4988 pololu step drivers. Set up step drivers for 16 microstep(all 3 msi high). At12v I turned the amp pot all the way down and then back up to 100-125mA on each axis. That seems to be where everything runs smoothly with still plenty of power and dose not get hot.

I will post my custom "Sphere cups" that I made from ninjaflex.

Print Settings

Printer Brand:

MakerGear

Printer:

M2

Rafts:

No

Supports:

No

More Makes

View More

Liked By

Make Info

1229
Top