Four bikes in front of the Freddie Mercury statue in Montreux, Switzerland. Not really - I took the statue photograph last week and thought that it would make a good background to show off these prints :-)
Two of them, the white one and the yellow one, are printed at the original size, the translucent blue one is scaled to x1.2 and the gold bike is x1.6 the original size.
Although they were all printed at 0.2mm layer height with a 0.4mm nozzle as recommended, my slicer refused to give me infill in some of the parts - the rear pannier holder was particularly 'fragile' in this respect. However, this is probably down to me using my standard profiles - I really need to play with the width:thickness ratio I think. The most substantial bike was the largest one - all parts nicely filled in and quite sturdy.
An excellent project though - no need for sanding, filing or even gluing together. Thank you for sharing.
Irrelevant for this height of build
Need to tweak slicer settings in order to get a good infill where needed.