This also works with a Galaxy S6 that has a protective shell.
Printing this was more difficult than I expected and I had one print abort (one of the pods came loose and then effectively destroyed the whole print). Next time I used a raft + support and the print made it.
If had to do this again and probably will since I'd rather print the top with some TPE (e.g. Ninja Flex with near solid infill) I would edit the openscad file, separate the pods from the top and then position the pods flat on the floor (support need to print the bottom tips).
The following should do this (change code at the end)
rotate ([90,0,0]) foot();
translate ([15,0,0]) rotate ([90,0,0]) foot30();
translate ([-15-8,-100,0]) rotate ([90,0,180]) foot30();
translate ([20,0,iClampLen-10]) body();
I finally reprinted the three feet with Bridge Nylon, since a PLA foot broke. I printed them lying flat on the bed.
First in print in PLA, one foot broke after some usage.
Second print of the feet in Bridge Nylon. I also will reprint the top with some TPE (e.g. Ninja Flex)