Printer in Carbon Fiber PLA for extra rigidity and an awesome matte black finish.
Hey, I noticed that you have modified x axis ends. I am in the process of upgrading my printer and have most of the parts printed. When you use those ends, do you achieve a greater printing area. Please directly reply if possible. I am very curious if it makes it easier to print those large parts. Thanks.
Yes. I was able to increase my X print width to 132mm (I also countersunk the two bed screws on on side). But those end peices are tricky to print because they barely fit on the 100x100. I had to fudge it a little and tell the printer it was 102x100.
I used my Z rods for the X upgrade then replaced my Z rods with new longer ones.