Wanhao i3 Glass Bed Brackets
Made by Dyne, uploaded
Thingiview
Description
Hatchbox Blue ABS. The silicone pad is to prevent the binder clip handles fron vibrating.
If you are wondering, the blue tape is there to keep the PETG I'm currently using from eating my borosilicate glass
Are you sure the clips needed are not medium size? I have both mini and "small" and neither will fit. Medium is one inch wide which looks like it would fit the groove it printed.
I'm assuming you intended to post this comment to the original object rather than here? I didn't mentioned anything about clip sizes.
Yeah...I did..sorry. What size clips DID you use?
They are 3/4" wide, which matches the width of small clips on amazon, so probably that.
Looks good! I just normally use clips on the glass directly unless I need full print volume then I bust out these bad boys:)