Wanhao Duplicator i3
How's the fit of the E3D hotend?
This one holds my E3D V6 significantly better than the default Prusa i3 Rework extruder body. It used to wobble a bit with the default one (never printed with it though), but it's a pretty snug fit with this.
My print has actually warped a little and is slightly off due to an issue with the Y-axis belt (I think) on my Wanhao Di3. Despite that the hotend fits quite snugly. Should be much better once I clamp it down with the right screws (the screws I have at the moment are just 20mm).
Thanks a lot for the design. :)