It works well, at least for homing I haven't tested it long term but seems stable, and definitely won't get hooked on bad prints that pop off or warp.

BigBox

No

No

.2mm

30%

Those were the settings of other prints and decided to throw it in there.

I was able to install it on the BB without taking the bed apart, but do so at your own risk.

I put it on the right side of the bed, so I loosened all of the screws on the right side of the bed, pryed the bed apart so I could rotate the current support out, you have to get the acrylic support piece out of the upper and lower acrylic bed pieces so you can rotate the piece free from the acrylic support.

There is a channel for the wires however it was a pain and wasn't deep enough for all three so I just didn't use it.