I used this model for a 7" screen purchased off Ebay. Ran out of filament before the model was finished printing, so the section around the eyes aren't quite as raised. Made some small modifications to accommodate the screen and the lenses that I had. There are cutouts for the HDMI out and power on the side. Also printed a cover piece for the back to cover up the driver board for the monitor. Had to shave off a half inch or so for the lenses to get the proper focus. Used some blue foam with sticky backing on the front for some added comfort around the eye area. And finally I added some rubber auto trim for some added comfort as well. Overall I think it came out pretty well.This was a replacement for a makeshift one that I put together a while back and it looks TONS better. It is also much more lightweight which I was my main goal of this project. I do want to reprint this again in the future so that I have all of the front part so that it covers all of the face, but this will do for now. Thanks so much for this great model!