Printed with PVA supports for a smooth finish. I painted the jewel afterwards with acrylic paint; I do not have a steady hand. I'll try to clean up the paint smear this week.
Why didn't you print it the other way around?
Printing it point up (third picture) rather than point down minimized the amount of support I needed.
Hehe, sorry, looked at picture 1 :)
you list that you didn't have a raft but isn't there a raft in your third picture?
Hi! No raft. If it was a raft, it's go under the whole thing. The clear printed parts are PVA dissolvable supports.