These are test prints to find out how it prints best, I will likely re-print this in red since that is my goal (visibility to not forget to remove it). I found that the best quality print at least for me was to print as-is in the file (standing up), it does require a bit more support in that direction but the support is easier to remove and the part looks much nicer as you can see in the pics. It is likely my printer settings but when laid down flat (X rotation set to 275 and then drop part on table in your slicing software) mine printed horribly, you cannot even make out that there was text on the inside (not that I care much for the text but I understand advertising). The piece printed standing up (first 5 pics) printed much nicer and you can almost make out the text even.
Sorry for the few blurry pics, did not realize there were blurry before removing the supports so could not re-take those pics.