The face came out great. Chest / hair was printed without supports, I enabled "detect bridging perimeters" to try to help with the overhangs around collar but still had a little bit or scarring there, but not any worse then support scars in my opinion. Just need to get some glue to put it all together. If I do it again I will likely scale it up to 150-200% to show off detail in face a little more and maybe increase to 0.1 layer height.
sliced with slic3r
face @ 0.05 layer height default settings, 4 hr print time
chest/hair @ 0.05 layer height, detect bridging perimeters enabled, 21.5 hr print time
stand @ 0.2 layer height, increased speed settings